Early pm.

Looking good except for missing trailer.

Brushes have been main concern last couple days. Still pondering that. Should both be done in the am…

Black Done Starting lines

lost a brush at 2522. This is more a frequent problem due to the stubby brushes hitting the edge of the canvas and decoupling with longer bristles not so much of problem.

Missing code…
i don’t remember what you did to warrant removing the first color from the ngc foreground. but basically it looks like it got chopped out prematurely. i could probably get somewhat close to isolating just the shapes you dropped but the above PNG shows all the strokes rendered in that color.

EMC had crashed so we split the file in half. We started the file at 2059. So I think it was just to reduce the file size.

I remember now. It crashed and I rolled it back to the last color mix. Must not have been painting anything for awhile before the crash. I’ll see what I can do but more than likely will end up painting a lot that doesn’t really need it.

That was the morning that the mixer arm had splattered shit every where and I made a new mixer arm. There was an area of drops and smears on the canvas. Who knows what happened it didn’t look like brush strokes though. I’ll send photo when this layer is done. I am reloading the paint. White ran out.

Can we get away with this

For sure. I’ll just watch it real close may be swap in a smaller brcush when we get out side the actual area. Might even sharpen it up.

Looks like you’re best off running with single tubes of everything and doing a black/white refill when needed.

Is the the Black redo or the lines. Speaking of VB4 EMC just took a dump.

reference image

Ok That’s what I thought! Thanks! We are back up. This should look good!

Just got done with L2 haven’t done the trailer yet.

Finished