Tapping a manifold for the top of the paint mixing engine the paint is to be delivered via vinyl tubes connected to the manifold barbs. The paint is to be pushed with compressed air with air pressure controlled by solenoid valves controlled by the computer.

Build notes:

Got a lot done tonight manifold is tapped and ported might be close by tomorrow. Will get paint tomorrow checked power supply getting ac. Talked to Tony will talk to the dude once we resolve relay issue.

04 10 2009

Replacement relays on the way.
Made the mixing cylinder auger and shaft.
I will pick power supply issue with Aurturo on Monday .

Cut glans for o-rings in shaft added set screw to the auger, drilled and tapped holes to connect to the maniflold, ported paint out hole, bored auger and bottom platte for bearing.