06-28-2010
wiring the control panel
Got the board layed out got the pigtails made etc.
Wednesday is looking like a working day.
07-01-2010
Good to see you today. Just have to hook up the motors and the mixer is done. Almost called you to bring in Sam to solder up the db9′s [reference to needing younger eyes to solder the fine connections on DB9 connectors]
07-02-2010
Mixer done! Got the power supplies on the controller wired up and fused. Have to run the 5v to the controllers and then wll hook up to 120 when it’s in it’s case.
07-08-2010
All wire stelatly tucked away as best as I acould route them. Machine has full travel. E-chain installed ready to comit to the connections. The thre pieces will seperate them selves from the cable with the removal of six bolts and six permanenly attached cable ties. Realized this am that the machine would not be able to broken down with the way the wires were running.
07-08-2010
control panel in the electrical box
07-09-2010
It’s all down hill soldering wise from here actually have some motors connected. Will be in in the am
